Directed Directechs DB3 Installation Manual - Page 10

Print Page

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

Remove the battery from the OEM remote to prevent the vehicle from arming.

Note: The firmware does not control the OEM alarm.

Wait until the LED turns ON solid red.

Note: To skip the transponder programming and use convenience features only, press the

programming button 5 times.

Turn the ignition ON. The LED will start to flash orange quickly then green. Turn ignition OFF.

Turn the key to ON, then back to OFF up to 10 times. The LED flashes orange slowly.

If the transponder programming was skipped, the LED turns ON solid orange for 3 seconds

then shuts OFF when programming is done.

When the LED starts flashing orange slowly, turn the ignition OFF, remove the module from

the vehicle and reconnect it to your computer. The web site will automatically recognize that

you are moving onto the second phase of the programming sequence.

Click on Submit Key2GO Request.

Once the configuration is completed, reconnect the module. The LED turns ON solid green for

3 seconds, then turns OFF.

You have successfully completed the module programming sequence.

403.CHRYSLER12 1.24 2019 Dodge/Ram ProMaster City