Directed Directechs DB3 Installation Manual - Page 10

Print Page

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

For

Convenience-Only

programming, see next section.

IMPORTANT! The vehicle battery must be in good condition and fully charged for successful

programming. A battery charger may be connected during programming if necessary.

The harnesses must be connected in this exact order:

a) Connect the 14-pin.

b) Connect the 12-pin.

c) Connect the 10-pin.

When the LED turns ON solid red, proceed with the next step.

With the brake depressed, press the Push-to-Start (PTS) button once (1) to start the vehicle.

The LED flashes orange quickly for approximately 5 seconds, then flashes green (it may flash

green for 30-60 seconds).

Note: If the LED flashes red 3 or 4 times after the initial 25 seconds, wait an extra 30

seconds.

If the LED turns ON solid green for 3 seconds then shuts OFF:

Press the PTS button once (1) more to turn ignition OFF.

You have successfully completed the module programming sequence.

If the LED starts flashing orange slowly, follow the Key2GO programming below.

Key2GO programming:

Press the PTS button once (1) more to turn ignition OFF, remove the module from the vehicle,

and reconnect it to your computer. The web site will automatically recognize that you are

moving onto the second phase of the programming sequence. Proceed with next step.

Click on Submit Key2GO Request.

Once the configuration is completed, reconnect the module.

The LED turns ON solid green for 3 seconds, then shuts OFF.

If however, the LED returns to flashing orange slowly, perform a soft reset on the module.

When the LED turns solid red, start the vehicle. The LED will turn ON solid green for 3

seconds then shuts off.

You have successfully completed the module programming sequence.

403.HONDA9 2.07 2023 Honda Civic (Smart Key)