Directed Directechs DB3 Installation Manual - Page 5

Print Page

Pre-installation and application warnings

This section highlights important information for this specific firmware and will assist in pricing accordingly, as

START

HERE

well as bringing awareness to any operational or vehicle limitations.

Compatibilities and Requirements

T-Harness

T-Harness is not compatible.

compatible

Vehicle Takeover

Firmware notes

Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the OBDII diagnostic connector.

Refer to the "Vehicle connections" following the installation diagram.

Footnotes

[1] Hood Pin: The installation of an aftermarket hood pin is only required on vehicles that are not equipped with a factory hood pin, or if

not supported in data.

[2] Tach: The tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[3] RAP OFF Output: If the RAP OFF wire is not connected, the radio will turn off but some lights will remain on in the central console for

up to 20 minutes. Connect this wire to the driver door sense trigger to avoid this issue.

[4] Telematics: CAN High and Low connections ONLY required to provide vehicle status when using a Directed SmartStart System.

403.GM7 4.11 2005 Pontiac G6

Refer to the Quick Reference Guide section for more details.

Keys required for

Keys required

programming

for operation