Directed Xpresskit DBALL2 Installation Manual - Page 5

Browse online or download pdf Installation Manual for Door locks Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 13 pages. Ford5 remote start ready (rsr) installation
Also for Directed Xpresskit DBALL2: Installation Manual (12 pages), Installation Manual (19 pages), Installation Manual (18 pages), Manual (14 pages), Installation Manual (14 pages), Installation Manual (19 pages), Installation Manual (16 pages), Installation Manual (20 pages), Installation Manual (15 pages), Installation And Quick Reference Manual (16 pages), Installation Manual (18 pages), Installation Manual (16 pages), Installation Manual (18 pages), Installation Manual (16 pages), Manual (19 pages)

Print Page

Platform: DBALL2

Firmware: CHRYSLER6

Module Programming

Refer to the LED Diagnostics section for more information and for troubleshooting purposes.

Important

Make all the required connections to the vehicle, as described in the wiring diagram(s) found in this guide, and double check to

ensure everything is correct prior to moving onto the next step.

Warning!

To take advantage of advanced features, you must use XpressVIP 4.5 or higher. Using version 2.9 or 3.1 will limit

available functions and features.

1. Connect the interface module to your computer using the XKLoader.

2. Open an Internet Explorer browser (version 6 or higher), and go to www.directechs.com. The detail of the platform and firmware

that is currently saved on the interface module will be indicated in the top right corner of the page.

3. Select the year, make and model of the vehicle; the page will refresh to display the compatible firmware.

4. In the search result page, select Flash Standard install, and follow the instructions provided on the screen.

5. Once you have configured your options, click on the FLASH button to upload the firmware onto the interface module.

6. The following message will be displayed when the upload is completed:

"The flashing is successfully completed. You may now unplug the kit."

You can now proceed with the programming instructions below.

D2D Installation

If required for your installation, connect the 10-pin, 12-pin and 14-pin harnesses to

the module, then connect the 4-pin D2D harness.

W2W Installation

If required for your installation, connect the 10-pin and 12-pin harnesses to the

module, then connect the 14-pin harness to the module.

Wait until the LED turns ON solid red.

Note: To skip the transponder programming and use convenience features

only, press the programming button 5 times.

Turn the key to ignition position, then back

to OFF position two (2) times.The LED

flashes orange slowly.

Disconnect the module and complete the Key2GO programming.

Key IN

Key OUT

START

Go to the next page for Key2GO programming.

Rev.: 20151029

Page 5

Solid

x 2

START

Flashes Slowly