Clarke 07127A Operator's Manual - Page 9

Browse online or download pdf Operator's Manual for Sander Clarke 07127A. Clarke 07127A 20 pages. American b-2+ dc 7" edger
Also for Clarke 07127A: User Manual (8 pages)

Print Page

HOW TO OPERATE THE MACHINE

DANGER:

Failure to remove the electrical plug from

the electrical outlet before attempting any

service or maintenance could result in

electrocution or severe injury. Always

unplug the machine before attempting any

service. Never leave machine unattended

while plugged in.

To operate the machine follow this procedure:

1. Move the machine to the location of your work.

2. Connect the extension cord to the short power

cord on the machine. See figure 3.

3. Connect the other end of the extension cord to the

power supply outlet.

4. Put the variable speed switch in the "HI" position

(1). See figure 4. After reaching full speed, put the

switch in the "LO" position if low speed is needed.

NOTE: The high speed operation is for fast wood removal.

For finish custs and custom work, use the low speed

operation.

5. Tilt the machine back so that the sandpaper disc

does not touch the floor See (1) in Figure 5. Hold

both handles. See (2) in Figure 5.

6. Put the On/Off switch in the "ON" position. See (3)

in Figure 5.

7. Keep the machine moving as you lower the

sandpaper disc to the floor surface.

8. Do not press down on the machine. The weight of

the machine gives enough pressure for all types of

sanding.

NOTE: Do not store or rest the machine on the sanding

disc assembly. It may cause the disc to become

warped or cause it to be out of balance.

MAINTENANCE

CAUTION: Maintenance and repairs performed

by unauthorized personnel could

result in damage or injury. Mainte-

nance and repairs performed by

unauthorized personnel will void your

warranty. Servicing of these units

must always be referred to an autho-

rized Clarke American Sanders

distributor.

Clarke American Sanders American B-2 Operator's Manual

Figure 3

Figure 4

Figure 5

Page 9