Aleko Victoria Series Installation Manual - Page 7

Browse online or download pdf Installation Manual for Accessories Aleko Victoria Series. Aleko Victoria Series 20 pages. Sizes 6.5x5 8x6.5 10x8
Also for Aleko Victoria Series: Instructions For Installation And Operation Manual (12 pages), Assembly Manual (14 pages), Installation Manual (17 pages)

Print Page

8. At this time, you will have one full-length roller, with all three roller tubes connected and screwed securely into place,

as seen in the diagram below.

STEP 3: Connecting Front Bars

1. Gather the three long, wedge-shaped front bars (C-1, C-2, C-3) and lay them in a line.

2. Also gather the two short, wedge-shaped connection pieces (C-C-1, C-C-2) and lay one between C-1 and C-3, and the

other between C-3 and C-2, as seen in the diagram below.

C-1

3. Insert the connector piece (C-C-1) into the interior end of the front bar on the left (C-1). If insertion is difficult, use a

mallet to tap it into place. Once inserted, screw it into place.

4. Repeat this process on the other side; insert the other connector piece (C-C-2) into the interior end of the front bar

on the right (C-2).

5. At this time, the connector pieces (C-C-1, C-C-2) will be connected to each of the outer front bars (C-1, C-2) and

secured with screws. A portion of the connector pieces will stick out of the front bars.

6. Now, connect the third remaining front bar (C-3) to the other side of the connector piece on the left (C-C-1) and

screw it into place, just like in step 3.

7. Repeat this process on the other side; connect the other front bar (C-3) to the remaining connector piece (C-C-2).

8. At this time, you will have one full-length front bar, with all three front bar pieces connected and screwed securely

into place.

A-1

C-C-1

C-1

C-C-1

C-1

A-3

Step 8

C-3

C-C-2

Steps 1 and 2

C-3

C-C-2

Steps 3 - 7

C-3

Step 8

A-2

C-2