Clarke METALWORKER CBB250 Operation & Maintenance Instructions Manual - Page 7
Browse online or download pdf Operation & Maintenance Instructions Manual for Sander Clarke METALWORKER CBB250. Clarke METALWORKER CBB250 13 pages. 250mm buffer/polisher
Print Page
ASSEMBLY
MOUNTING THE MACHINE
1. Bolt the buffer/polisher to a
workbench using the securing holes
shown.
• DO NOT block the ventilation
paths through the base.
• Check that the installation is
secure before turning the
buffer on.
FITTING BUFFING/POLISHING PADS
1. Place the spacer over the shaft.
2. Place the polishing mop between the washers and secure with the retaining
nut, hand tight.
• The shaft threaded ends are handed LH and RH.
3. Tighten the nuts enough to grip without crushing the buffing/polishing pad.
NOTE: Wheel rotation, when in use, will tighten the retaining nut.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7