Aleko BSW03 Quick Start Manual - Page 3

Browse online or download pdf Quick Start Manual for Swing Set Aleko BSW03. Aleko BSW03 3 pages. Dual swing set

Print Page

Step 4. Insert 1 Bottom Leg into the open end of each of the 4 Top Legs. Place a

F2 fastener into each of the holes at the junction, making sure the exposed

threaded end is pointed away from the Swings.

Step 5. Place Side Stay Bar over the exposed fastener ends so that the flat side

of the Stay Bar ends is in contact with the Top/Lower Leg assembly.

Step 6. Tighten F2 nut down onto Side Stay Bar.

Anchoring Swing Set to Ground

Step 1. Attach Ground Pegs to all 4 Nest Swing Bottom Legs using P1 fasteners.

Step 2. Place assembled Swing Set in desired location and dig a footing hole,

measuring 12" (30cm) Long x 12" (30cm) Wide x 20" (50cm) Deep, at the base

of each support leg.

Step 3. Prepare and pour concrete into the footing holes following concrete

manufacturer's instructions. Fully fill footing holes to be level with ground surface.

Step 4. While Concrete is still wet, angle Ground Pegs toward swingset Top Bar

at roughly 120-degrees, then insert Ground Pegs into concrete footing, making

sure Swingset Bottom Legs do not sink below ground surface (utilize concrete set

time information). Use temporary support made from wood or other material if

necessary to prevent sinkage.

Swing Set will be ready for use once concrete is fully set and cured (consult

concrete manufacturer's instructions).

Visit www.aleko.com for Tech Support, Customer Service and more great

products for your Home, Garden, Patio, and Pets!