Clarke Super 7R Edger 07125A Manual - Page 2

Browse online or download pdf Manual for Sander Clarke Super 7R Edger 07125A. Clarke Super 7R Edger 07125A 6 pages.

Print Page

Switch Replacement

1-Remove the two screws (14) securing the switch cover

2-Remove tape from switch to expose wiring connections

3-Disconnect all wires

4-Remove switch retaining nut (3)

Assembly Hints

Connect the light wires with the incoming power wires on the switch so that the light is on when machine is plugged in

Always retape the switch to prevent shorting between metal objects inside machine

Pigtail Replacement

1-Remove the two screws (14) securing the switch cover

2-Remove tape from switch to expose wiring connections

3-Disconnect the black and white pigtail wires from the switch and the ground wire (35) from the handle housing

4-Remove pigtail and strain relief assembly from Handle housing.

Assembly Hints

Always retape the switch to prevent shorting between metal objects inside machine

Motor Brush Replacement

1-Remove vent plugs (7) and cover plates (5) (6)

2-Disconnect brush shunt wires from the brush block (Fig. 15)

4-Remove the brush springs(38) by pushing in and toward the brush (Fig. 16)

5-Remove brushes (9)

Brush Block Replacement

1-Remove four screws (1) securing handle housing

2-Lift handle housing (36) up (Fig. 17)

3-Disconnect white field wire and black switch wire from brush block

4-Remove four screws (10) securing brush block

Assembly Hints

When reinstalling the handle housing pay special attention not to pinch field wires between the handle and field housing.

Use a small amount of grease to hold the load spring (52) in the handle while assembling.

All four brush springs must be removed and the brushes retracted.

Fig. 15

Fig. 16

Fig. 17

56043142

Page 2