Directed Electronics 1000HF Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Car Alarm Directed Electronics 1000HF. Directed Electronics 1000HF 8 pages. Python code hopping high frequency 6/96 change model 1000 owner's guide

Print Page

Code Hopping

The receiver and transmitters each use a mathematical formula called an

algorithm to change their code each time the transmitter is used. This technol-

ogy has been developed to increase the security of the unit. The control unit

knows what the next codes should be. This helps to keep the transmitter "in

synch" with the control unit even if you use the remote control out of range of

the vehicle. However, if the transmitter has been pressed many times out of

range of the vehicle, or the battery has been removed, it may get out of synch

with the control unit and fail to operate the system. To re-synch the remote

control simply press the arm/disarm button of the remote control several times

within range of the vehicle. The alarm will automatically re-synch and respond

to the transmitters normally.

High Frequency

Your system transmits and receives at 434 MHz. This provides a cleaner

spectrum with less interference and a more stable signal. Enjoy a phenomenal

increase in range - even in areas with high radio interference.

Programming Options

Programming options control what your system does during normal operation,

and require little or no additional parts. However, some may require additional

installation labor.

The following is a list of the programmable options, with the factory settings in

Bold.

•

Active arming (only with the transmitter) or passive arming (automatic

arming 30 seconds after the last door has been closed).

•

Arming/disarming confirmation siren chirps on or off.

•

Passive door locking (with passive arming) or active door locking (only

when arming with the transmitter) . This feature only works if passive

arming has been selected for step one.

•

The ignition-controlled door locking feature on or off. With this feature on,

the doors will lock 3 seconds after the key is turned on, and unlock when

™

XPLAINED

Panic Mode

If you are threatened in or near your vehicle, you can attract attention by

triggering the system with your transmitter! Just press button I for 1.5 seconds,

and you will enter Panic Mode. The siren will sound and the parking lights will

flash for 30 seconds. To stop Panic Mode at any time, press button I on the

transmitter again.

Valet

Mode

You can prevent your system from automatically arming and triggering by

using Valet

Mode. This is very useful when washing the vehicle or having it

serviced. In Valet

but all convenience functions (door locks, trunk release, etc.) will work

normally.

To enter or exit Valet

Turn ignition to "run" position, then turn to "off" position.

Press and release the Valet

The Status LED will light steady if you have entered Valet

it will go out if you exited Valet

Remote Valet

Using

Open any door.

Press button I (or the arm/disarm button).

Press button II (or the channel 2 button).

Press button I again.

The Status LED will light steady if you have entered Valet

and it will go out if you exited Valet

G438.696

95G438.PM5

Mode, the system will not arm, even with the transmitter,

Mode with the Valet

switch:

switch within 10 seconds.

Mode.

as you enter or exit the vehicle:

Mode.

Mode, and

Mode,

G438.696

95G438.PM5