Alelion 1003220 User Manual - Page 11

Browse online or download pdf User Manual for Camera Accessories Alelion 1003220. Alelion 1003220 16 pages. Lithium ion battery

Print Page
Remove charger, wait in an indoor environment +5°C to +30°C for four to five (4-5h) hours,
even longer if you suspect that temperature is too high or too low.
Try again to put the EasyPower battery on charge in an indoor environment +5°C to +30°C.
If the EasyPower battery still will not charge, contact service personnel.
If the EasyPower battery charges slowly it can be caused by:
o
Unbalanced cells
o
Too high or low battery/cell temperature
Charge the EasyPower battery in an indoor environment +5°C to +30°C during at least five
(5h) hours.
If the charger still not indicates that the EasyPower is fully charged, contact service
personnel.

Recycling

The batteries shall be sent back to the importer in the country of usage or be recycled in
accordance with national environmental protection regulations or disposal laws.
Cell designation according to IEC 62620: ICNMP/28/149/95/H/-30+55/95
Observe that during transport the Easy Power battery shall be handled as dangerous goods,
according to UN3480 Class 9.
o
The external terminals shall be protected from short circuit
o
Normal or superannuated batteries shall be packed according to P903
Only personnel with training for transport of dangerous goods (1.3 training according to UN
38.3) are allowed to pack and mark the goods.

Repair

If it is necessary to repair the EasyPower battery, some parts can be replaced by the field
service but any fault in the internal parts must be repaired at a service center.
Always contact your service organization*, when the EasyPower battery is suspected to be
faulty and before returning the EasyPower battery. *(same as for the lift truck.)
Observe that during transport the Easy Power battery shall be handled as dangerous goods,
according to UN3480 Class 9.
o
The external terminals shall be protected from short circuit
o
Damaged/defective batteries shall be packed according to P908 and LP904
Only personnel with training for transport of dangerous goods (1.3 training according to UN
38.3) are allowed to pack and mark the goods.
2016-06-09, 1004070-001
11