Clarke 7230024 Operation & Maintenance Instructions Manual - Page 5

Browse online or download pdf Operation & Maintenance Instructions Manual for Water Pump Clarke 7230024. Clarke 7230024 13 pages. Submersible pump

Print Page

ELECTRICAL CONNECTIONS -110V UNITS

HIPPO 2 - 110 VOLT UNITS

This product can be connected to one of the following power supplies:

• 110V generator

• 110V isolating transformer

• 110V site supply

• 230V generator via a 110V transformer.

Connecting it to any other power source may cause damage.

This product includes a fitted industrial plug to BS-EN

60309, and a cable for use with a 110 volt supply. On

no account must a 230V, 13amp (BS1363) plug be

used.

If using a portable 110V transformer, make sure it has a

rated capacity sufficient to take the load of the

pump.

Should the plug need changing at any time, ensure

that a plug of identical specification is used and

proceed as follows:

1. Undo the socket screws & remove the rear section.

2. Rotate the cable clamp clear of the terminals.

3. Feed the cable through the rear gland in the plug.

4. Remove the cable sheath to the required lengths

as shown in the diagram.

5. Terminate the correct wires in the

correct terminal blocks as shown.

6. Remove the cable clamp screws. Clip

the cable clamp back into position and

place the clamp around the outer

sheath of the cable. Replace the screws

and tighten until the cable is securely

held.

7. Replace the rear cover and tighten the cover screws.

If in any doubt, consult a qualified electrician. DO NOT attempt any repairs

yourself.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]