Clarke CGP870 Operation & Maintenance Instructions Manual - Page 10
Browse online or download pdf Operation & Maintenance Instructions Manual for Water Pump Clarke CGP870. Clarke CGP870 17 pages. 870w grinder/slurry pump
Print Page
CLEANING, MAINTENANCE & STORAGE
WARNING: MAKE SURE THAT THE PUMP IS DISCONNECTED FROM THE
POWER SUPPLY BEFORE CLEANING OR PERFORMING MAINTENANCE
The pump should require no maintenance other than regular cleaning.
1. Inspect the pump prior to use and do not use the pump if there is any
damage to the mains power cable.
2. Check pump regularly to ensure the inlet is clear of leaves or other debris. It
can be cleaned out either by back-flushing or by cleaning out by hand.
Take extra care to remove any debris from around the impeller.
3. If the pump has been used for pumping swimming pool water or salty
water likely to leave chemical residues, it should be flushed through with
clean water before storage.
4. When the pump is not being used for extended periods, clean and dry it
thoroughly and store in indoors. if the pump is left in water, it should be run
at least once a week to prevent it from seizing up.
5. If the pump shows signs of wear or damage, contact your CLARKE dealer
for advice. Do not attempt to repair the pump yourself, as you may
damage the waterproof seals and invalidate your guarantee. Repairs
should be carried out by your local CLARKE dealer, or contact the CLARKE
Service Department on 020 8988 7400.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
10