Clarke CPE20T Operation & Maintenance Instructions Manual - Page 8

Browse online or download pdf Operation & Maintenance Instructions Manual for Water Pump Clarke CPE20T. Clarke CPE20T 14 pages. Cpe range pumps

Print Page

Maintenance

No regular maintenance is required other than regular inspection to ensure that leaves

and other particles are not covering the suction inlet, also check the pump for signs of wear

or damage.

If any signs of wear or damage are found, contact your nearest Clarke dealer.

If you suspect that your pump is blocked by mud, silt , leaves etc, disconnect from

the mains supply and backflush. This should dislodge any blockage and aid cleaning.

there is little likelihood of problems arising, but if water will not flow as it should then check

the following points:-

The pump does not run

Pump runs but no output

Low or no Flow

Should you still experience problems, then contact your Clarke dealer, or CLARKE

International Service Department for advice.

SERVICE:

1. No mains supply

2. Impeller seized / blocked

1. Air in pump housing

2. Suction height too great

1. Blocked inlet pipe

2. Head too high

PARTS & SERVICE TEL: 020 8988 7400

e-mail as follows:

1. Check fuse - replace if

necessary (Check fuse rating).

2. Disconnect pump from mains,

investigate cause and clear

blockage etc..

1. Disconnect from the mains and

check all hose connections

are air tight etc.

2. Check height is within spec. for

your pump, (see specs page 2).

1. Check to see that no foreign

matter is fouling the intake

system and check the filter is

not blocked or obstructed.

2. Check that head is within spec.

-7-