Clarke CSV2A Operation & Maintenance Instructions Manual - Page 7

Browse online or download pdf Operation & Maintenance Instructions Manual for Water Pump Clarke CSV2A. Clarke CSV2A 13 pages. Submersible water pump
Also for Clarke CSV2A: Operation & Maintenance Instructions Manual (17 pages)

Print Page

MAINTENANCE

WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT

IS UNPLUGGED FROM THE MAINS SUPPLY. IF THE UNIT IS HARD WIRED,

ENSURE THE CIRCUIT BREAKER IS OPEN.

These pumps should require no maintenance other than regular cleaning.

If the pump starts to show signs of wear or damage, contact your CLARKE

dealer for advice.

• Do not use the pump if there is any damage to the mains supply

cable or to the float switch or its cable.

• Do not attempt to repair the pump yourself, as you may damage

the waterproof seal and invalidate your guarantee. Repairs must be

carried out by your CLARKE dealer or contact the CLARKE Service

Department on 020 8988 7400.

• If the troubleshooting on page 8 does not solve your problem,

please contact the Clarke service department.

CLEANING

1. Check the pump installation regularly to ensure the base inlet is clear of

leaves or other debris.

• These pumps have screwless fittings at

their base, allowing the removal of the

plastic cover by prising the two

release clips apart in the direction of

the arrows.

• This allows better access to the cavity

at the bottom, should the pump

become badly clogged. Flush the

cavity and the impeller housing with

clean water.

• To replace the cover, ensure the

release clips line up with the holes on the base of the pump and

press the cover home.

NOTE: Do not attempt to strip the pump further as this will invalidate the

guarantee.