Directed Electronics 4103 Series Installation Manual - Page 17
Browse online or download pdf Installation Manual for Remote Starter Directed Electronics 4103 Series. Directed Electronics 4103 Series 20 pages. Remote start with keyless entry; multi-button remote
Also for Directed Electronics 4103 Series: Quick Reference Install Manual (2 pages)
Reset and deletion
If a feature/virtual tach needs to be reset or the remote controls need to be deleted, use the following proce-
dure.
1. Turn the ignition to the ON position (The heavy gauge pink wire must be connected).
2. Within 10 seconds, press and release the Valet button: 2 times if you want to delete remotes, 3 times to
reset features or 4 times to reset virtual tach. These features are described next.
Delete remotes: This feature erases all remotes from the memory of the system. This is useful in cases
when a customer's remote is lost or stolen.
Note: This does not reset the programmed features of the system or reset the Virtual Tach setting.
Reset Features: This resets all features of the system to the factory default settings.
Note: This feature does not delete the remotes from the system or reset the Virtual Tach setting
Virtual Tach Reset: Deletes all previously learned values for Virtual Tach, and on the next remote start
sequence the unit begins virtual tach initialization.
Note: The "Zap" feature on the Bitwriter does not reset the Virtual tach setting.
3. Once you have selected the function step, press the Valet button once more and hold it. The LED flashes
and the horn honks to confirm the selected functional step. Do not release the Valet button
4. While holding the Valet button, press the
the feature has been successfully reset.
Once the feature is reset, the Valet button can be released.
Troubleshooting: Keyless entry
Door locks operate backwards.
•
This unit has easily-reversed lock/unlock outputs. Recheck wire connections to see if you have re-
versed these.
Troubleshooting: Remote start
The remote will not activate the remote start
1. Does the neutral safety input have a ground? if the wire is not grounded the remote start will not
activate.
2. Have you performed the remote start shutdown diagnostics? Sometimes an active shutdown input will
report in the diagnostics.
3. Is the remote programmed to the system?
4. Can the remote start be activated manually by applying a ground pulse to the H1/4 White/Blue
wire?
5. Check the harnesses and their connections. Make sure that the harnesses are completely plugged into
the remote start module. Make sure there are good connections to the vehicle wiring.
6. Check voltage and fuses on the system.
© 2012 Directed. All rights reserved.
button on the remote control. The horn honks to confirm that
AUX
17