Directed Electronics AS-1271U User Manual - Page 10

Browse online or download pdf User Manual for Remote Starter Directed Electronics AS-1271U. Directed Electronics AS-1271U 12 pages.

Print Page

Secure Lock

(Disabled by default.) Before your vehicle can be remote-started, the factory security system must

first be disarmed. The Secure Lock feature may be required on certain vehicle models with factory

security systems that automatically unlock the doors when the security system is disarmed.

To keep your vehicle protected when the factory security system is disarmed for a remote start,

Secure Lock will relock your doors as soon as the vehicle is started. Once the engine is shut down

by remote or after its runtime has expired, Secure Lock will also rearm your factory security system

and relock the doors.

Passive or Active Arming

Note 1: Passive and active arming is only used when a starter kill is installed to your vehicle

Note 2: This feature is only available if the

Active Mode: The system will not arm automatically. Press

Starter Kill.

Passive Mode: The system will automatically arm itself unless remote-armed within 1 minute.

Press

to either arm or disarm the Starter Kill.

Engine Run Time

If you have a gas engine, your system can be programmed to run the engine for 3, 15, or

25 minutes (15 min default). If you have a diesel engine, it can be programmed to run the engine

for 8, 20, or 30 minutes (20 min default).

Turbo Mode

Note: Turbo Mode can be activated only if

If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user

leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it

is shut down by remote control), then shut down the engine.

If the vehicle has an automatic transmission, proceed as follows to set the system to Turbo Mode:

With the engine running, make sure to release the brake pedal and press the

the transmitter until the parking lights come ON.

Note: SmartStart™ can be setup to use the SmartStart™ icon to activate Turbo mode.

Remove the ignition key from the ignition switch.

The engine will continue running.

Exit the vehicle and close all doors, hood and trunk.

Press the

The engine will shut down after 60 seconds.

If your vehicle has a manual transmission, Turbo Mode can be activated only if

programmed as a LOCK or UNLOCK button. Turbo Mode is activated through the same routine as

that used for Ready Mode (page 4); at the last step,

Note: The vehicle will enter Ready Mode once the engine run time expires.

P.10

; this will lock the doors and arm the Starter Kill.

button is configured as LOCK or UNLOCK.

is programmed as a LOCK or UNLOCK button.

is pressed.

to either arm or disarm the

User Guide