Directed Electronics AutoCommand 40026 Installation Manual
Browse online or download pdf Installation Manual for Remote Starter Directed Electronics AutoCommand 40026. Directed Electronics AutoCommand 40026 20 pages. Remote car starter
Print Page
Remote Car Starter Installation Manual for Models 40026, 40026T
Congratulations on your purchase of the AutoCommand
from the comfort of your home or office in order to cool it down in the summer or heat it up in the winter.
AutoCommand
®
is for automatic transmission, fuel injected gasoline vehicles only. Please see pages 6-7 for important information about vehicles with factory
anti-theft systems. AutoCommand
• Will start your car by remote control, and run the heater, defroster,
or air conditioner to warm up or cool down the car.
• Is designed to start the car if it is in park, and only if the
hood is closed.
• Will attempt to start the car for up to six seconds, but no
longer (to avoid damage to the starter motor). Should the
car not start, or if it stalls after starting, the remote starter
will make two further attempts to start it.
• Will not let the car be driven without the key in the ignition.
Tools required to install the AutoCommand
Wire Cutters/Strippers
Soldering Iron
Pliers
Testmeter
We highly recommend that all connections be soldered for reliability.
Parts included with the AutoCommand
Remote Starter Receiver Module
Transmitter
Antenna with Custom Clip
Control Harness (6 position)
6 Power & Ignition Wires
Yellow Headlight Wire
The following parts are included in the plastic bag:
Alcohol Pad
Alchohol
Pad
Green 30 A Fuse
On/Off Control Switch
Warning Label
WARNING
This car is equipped with a remote control starting device.
Disable before working on car!
AVERTISSEMENT
Co véhicule est équipé d'un systéme de démarrage á distance. Mettez-le hors
fonctuin avant d'eflectuer toule opération d'entretian ou de répanation!
2 Protected by
DesignTech Labels
© 2005 Directed Electronics, Inc.
www.designtech-intl.com • www.directed.com • 800-876-0800
PLEASE READ COMPLETELY BEFORE BEGINNING
®
Remote Car Starter. AutoCommand
®
is an extremely sophisticated system with multiple built-in safety and security features.
AutoCommand
®
System:
Electrical Tape
Screwdriver
Drill with
1
/
"and
4
drill bits
®
System:
Ring Terminal
Hood Pin Switch Set
2 Cable Ties
Yellow Butt Connector
®
Remote Car Starter allows you to start the car by remote control
®
Remote Car Starter:
• Shuts itself off automatically after 10 or 15 minutes
(programmable) if you forget to come out to your car.
• Will shut off if the brake pedal is pushed, the hood is opened,
or the transmission is shifted out of park - unless the key is
in the ignition and in the "run" position.
• Is quality engineered and microprocessor controlled to
provide many years of reliable use.
• Comes with a Limited Lifetime Warranty.
Power Harness
5
/
"
16
ON/OFF Switch Jack
Control Harness
Color
Function
Green
Tach
Brown/White
Alarm Disarm
W
hite/Black
IGN 3
Color
Function
Circuit Type
Purple
Hood Switch
(-) Input
Orange
Brake
(+) Input
Blue
Horn
(-) 400mA Output
* For free vehicle specific wire information, consult
our website at www.designtech-intl.com
1
Wiring Diagram
Circuit
Color
Function
Type
Pink
Power (+12V) Input
White
Accessory
Relay output
Yellow
Starter
Relay output
Blue
Ignition 1
Relay output
Green
Ignition 2
Relay output
Black
Ground
Input
Small Yellow
Headlights
Relayoutput
Coax
Antenna Jack
Circuit Type
Required
(-) Input
No
(–) 400 mA Output
Consult Wiring Guide*
(–) 400 mA Output
Consult Wiring Guide*
Required
Yes
Yes
No
Required
Yes
Yes
Yes
Yes
Consult Wiring Guide*
Yes
Optional
v5.3 (40026)