Directed Electronics Xpresskit SoleX Series Installation Manual - Page 5

Browse online or download pdf Installation Manual for Automobile Accessories Directed Electronics Xpresskit SoleX Series. Directed Electronics Xpresskit SoleX Series 9 pages.

Print Page
The Mobile Integration Systems
Platform: XK09
Firmware: CHRYSLER3

Module Programming

Takeover with GET IN AND GO*
- Enter the vehicle with the factory proximity key
- Press the brake pedal
*GET IN AND GO connections required
Takeover without GET IN AND GO
- Enter the vehicle with the factory proximity key
- Press the Push-to-Start (PTS) button twice
- Press the brake pedal
Refer to the LED Diagnostics section on page 7 for more information and for troubleshooting purposes.
If connected in D2D:
Connect the 4-pin D2D and the 20-pin harnesses.
If connected in W2W:
Connect the 20-pin harness.
1
Caution! The 20-pin connector can be easily plugged in backwards.
The LED turns ON solid.
Connect one or both of the other 4-pin harnesses, depending on
2
the requirements of each installation types.
3
Make sure the key is inside the vehicle.
Press the Push-To-Start (PTS) button twice to turn
4
the ignition ON without pressing on the brake pedal.
The LED will stay ON solid for 3 seconds, then turn OFF.
Press the PTS button once more to turn the ignition OFF.
5
The module is programmed and ready to use.
4-pin
20-pin
On Solid
4-pin
x2
x2
PANIC
ENGINE
PUSH
START
STOP
&
Flashes
Press 2x
© 2011 Directed Electronics. All rights reserved.
Rev.: 20111122
Page 5
Key Inside the Vehicle
&
&
On x3 Secs
Off
ENGINE
1X
PUSH
START
STOP