Directed Electronics Viper 400.2 Owner's Manual - Page 8

Browse online or download pdf Owner's Manual for Amplifier Directed Electronics Viper 400.2. Directed Electronics Viper 400.2 16 pages. Direct electronic power amplifier owner's manual

Print Page

FRONT PANEL CONNECTIONS/STATUS LED

1. R R C C A A O O u u t t p p u u t t J J a a c c k k s s - These pass

through RCA jacks can be used to

send a signal to a second amplifier.

2. R R C C A A I I n n p p u u t t J J a a c c k k s s - Accepts line level

outputs from head units or signal

processors at voltages between

150mV and 8 volts.

FIGURE 1—AMPLIFIER CONNECTIONS 400.2 FRONT

REAR PANEL CONNECTIONS

1. S S p p e e a a k k e e r r O O u u t t T T e e r r m m i i n n a a l l s s - Connect

the speakers to these terminals.

(Refer to the Speaker Connection

section of this guide.)

2. R R e e m m o o t t e e T T u u r r n n O O n n - This terminal

turns on the amplifier when (+) 12

volt is applied to it. Connect it to

the remote turn on lead of the head

unit or signal source. If a (+) 12

volt remote turn lead is not avail-

able, a Remote Power Adapter

3. S S t t a a t t u u s s L L E E D D - Will light green to indi-

cate the amplifier is on and oper-

ating normally and will be off if the

amplifier shuts down due to short

circuit, DC offset, or overheating

detected by on-board protection

circuitry.

(P/N #55000) can be used to

supply a remote turn on signal. DO

NOT connect this terminal to

constant (+) 12 volt.

3. P P o o w w e e r r F F u u s s e e s s - These fuses protect

the amplifier against internal elec-

trical damage and are meant to

protect the amplifier only. All other

power connections should be fused

at the source.