Directed Electronics Viper Audio 550.6 Owner's Manual - Page 10

Browse online or download pdf Owner's Manual for Amplifier Directed Electronics Viper Audio 550.6. Directed Electronics Viper Audio 550.6 16 pages. Directed electronics, inc power amplifier owner's manual

Print Page

Directed Electronics Viper Audio 550.6 Owner's Manual

TOP PANEL CONTROLS

1. I I n n p p u u t t G G a a i i n n A A d d j j u u s s t t m m e e n n t t - Controls

amplifier sensitivity and is used to

match the input level of the amplifier

to the output level of the signal

source.

2. C C r r o o s s s s o o v v e e r r S S e e l l e e c c t t i i o o n n S S w w i i t t c c h h -

Controls the type of filter for the on-

board active crossovers. FLAT does

not attenuate any frequencies and is

for full range speaker systems. HPF

attenuates low frequencies and is

used for mid range speakers and

tweeters. LPF attenuates high

frequencies and is typically used for

subwoofers.

3. O O u u t t p p u u t t C C r r o o s s s s o o v v e e r r F F r r e e q q u u e e n n c c y y A A d d j j u u s s t t -

m m e e n n t t - Adjusts the crossover point

for the on-board active crossover for

the 1-4 OUT RCA jacks.

FIGURE 3—AMPLIFIER CONTROLS TOP

4. C C r r o o s s s s o o v v e e r r F F r r e e q q u u e e n n c c y y A A d d j j u u s s t t m m e e n n t t -

Adjusts the crossover point for the

on-board active crossovers.

5. V V a a r r i i a a b b l l e e B B a a s s s s E E Q Q - Adds 0 to12db of

additional boost to channels five

and six output when active.

6. I I n n p p u u t t P P a a r r a a l l l l e e l l S S w w i i t t c c h h - Controls the

input signal to the indicated channels.

If the 3+4 switch is ON, channels

three and four will derive their signal

from channels one and two RCA jacks

and no input is needed. If the 3+4

switch is OFF, channels three and four

RCA jacks must have input. If the

5+6 switch is ON, channels five and

six will derive their signals from chan-

nels one through four RCA jacks and

no input is needed. If the 5+6 switch

is OFF, channels five and six RCA

jacks must have input.