Directed Video WHS208 User Manual

Browse online or download pdf User Manual for Headphone Directed Video WHS208. Directed Video WHS208 1 pages. Two channel automotive wireless headphone system

Print Page

P P a a r r t t s s S S u u p p p p l l i i e e d d

One IR Transmitter.

Two IR Transmitter Harness.

Two IR 2-Channel Headphones

I I m m p p o o r r t t a a n n t t N N o o t t e e s s

For best results, the IR transmitter must be installed as shown in figure 1

with the LEDs pointing towards the rear of the vehicle.

Audio input can be connected to either a low-level fixed audio output or a

variable level audio output (such as a speaker or headphone output). If it is

connected to a low-level output, only the volume control on the headphones

needs to be adjusted to control volume level. If connected to a variable level

outputs, then the volume adjustment needs to be accomplished at both the

sources and at the headphones.

W W i i r r e e H H a a r r n n e e s s s s ( ( w w i i t t h h R R C C A A c c o o n n n n e e c c t t o o r r s s ) )

1. Using two dual RCA (M/M) cables (not supplied—length to be determined

by installation requirements), connect one end of each to the Red and White

RCA jacks. Connect the other ends to the channel A and channel B to each

of the low level signal sources (A and B).

2. Connect pin 4 of the channel A harnness (Black wire, negative) to the

ground of the vehicle.

3. Connect pin 5 of the channel A harness (Red wire, +12 volt) to the igni-

tion source. This is an ignition wire that provides +12V when the ignition key

is turned on.

I I R R T T r r a a n n s s m m i i t t t t e e r r

1. Plug wire harness into transmitter.

2. Remove the 2 plastic caps on the transmitter to exposed the mounting

screw holes (figure 3).

3. Fasten transmitter to headliner using two short metal screws. U U s s e e c c a a u u - -

t t i i o o n n , , d d o o n n o o t t d d r r i i l l l l t t h h r r o o u u g g h h t t h h e e r r o o o o f f o o f f t t h h e e v v e e h h i i c c l l e e . . L L o o c c a a t t e e a a r r o o o o f f m m e e t t a a l l b b e e a a m m

o o r r g g l l u u e e a a p p i i e e c c e e o o f f w w o o o o d d t t o o t t h h e e m m e e t t a a l l r r o o o o f f . .

4. Reinstall the plastic caps.

2 2 - - C C h h a a n n n n e e l l W W i i r r e e l l e e s s s s H H e e a a d d p p h h o o n n e e s s

Follow the instuctions with the owner's manual for the headphones for prop-

er operation.

F F i i g g u u r r e e 1 1 — — T T r r a a n n s s m m i i t t t t e e r r M M o o u u n n t t i i n n g g D D i i a a g g r r a a m m

W W H H S S 2 2 0 0 8 8 T T W W O O C C H H A A N N N N E E L L A A U U T T O O M M O O T T I I V V E E W W I I R R E E L L E E S S S S

H H E E A A D D P P H H O O N N E E S S Y Y S S T T E E M M

F F i i g g u u r r e e 1 1 — — T T r r a a n n s s m m i i t t t t e e r r M M o o u u n n t t i i n n g g D D i i a a g g r r a a m m , , c c o o n n t t i i n n u u e e d d

F F i i g g u u r r e e 2 2 — — W W i i r r i i n n g g H H a a r r n n e e s s s s e e s s

F F i i g g u u r r e e 3 3 — — I I R R T T r r a a n n s s m m i i t t t t e e r r

N88408 10-05