Clarke 6920290 Operating & Maintenance Instructions - Page 8

Browse online or download pdf Operating & Maintenance Instructions for Heater Clarke 6920290. Clarke 6920290 20 pages. Paraffin/diesel heaters

Print Page

STARTING PROCEDURE

Before starting the heater, you MUST ensure that the minimum ventilation

requirements are observed, to avoid the risk of carbon monoxide poisoning.

Ensure the fuel tank is filled with the correct fuel, before plugging in to a suitably

earthed supply. If you are changing the type of fuel, ensure the blanking plate at

the rear of the burner is set to the correct position (see Notes on page 7).

It will be necessary to remove the top cover, by removing its 6 securing screws, to

gain access to the rear of the burner, and the blanking plate.

If necessary, slacken off the blanking plate securing screw, turn the plate to its

required position and tighten the securing screw. Replace the top cover,

then,observing all precautions previously stated, push The start switch

located on the left side of the machine, and shown at 8, fig. 1.

It is important to ensure that adequate ventilation is provided. The following chart

gives the MINIMUM requirements

Heater Model

eg. For XR75, a 3ft window must be open by 10" minimum

PARTS & SERVICE

CLARKE International, on one of the following numbers.

PARTS & SERVICE TEL: 020 8988 7400

PARTS & SERVICE FAX: 020 8558 3622

Minimum fresh air opening requirements

Ventilation ft

XR55

XR75

XR105

XR155

Please contact your nearest dealer, or

or e-mail as follows:

Warning!

Minimum

1.6

2.5

3.0

4.6

Minimum

Ventilation mtrs

0.15

0.23

0.28

0.43

- '1'