Clarke DEVIL 350 230V Operating & Maintenance Instructions - Page 7

Browse online or download pdf Operating & Maintenance Instructions for Heater Clarke DEVIL 350 230V. Clarke DEVIL 350 230V 13 pages.

Print Page

INSTRUCTIONS FOR USE

1. Place the heater on a firm, level

surface and following all safety

precautions, plug into a suitable

mains supply. The neon indicator

will illuminate.

2. Set one, or both switches to the I

(On) position as required.

• Two power settings are

available. Each switch will

illuminate to show that the

upper or lower heat element is in use.

• The output of each heating element is 1200 W (4100 BTU).

CAUTION: PLEASE NOTE THAT THE HEATING ELEMENTS OF THIS PRODUCT

DO NOT GLOW WHILST IN OPERATION. ANY PICTURES SHOWING THIS IN

ADVERTISING MATERIAL ARE FOR ILLUSTRATION ONLY.

NOTE: The heater is equipped with an anti-tilt switch that automatically

shuts the power off should the heater tip over. If this happens,

simply place the heater in its correct position and it will

immediately rest

CLEANING & MAINTENANCE

ALWAYS allow the heater to cool down for at least 15 minutes and disconnect

it from the mains supply before performing any maintenance tasks.

PERIODICALLY

1. Inspect the power cable for damage. Undue heat will cause the cable to

stiffen and crack. If this is found, have the cable replaced. Check cable

routing and ensure it is well away from the heat source.

2. Should the heater become dirty, disconnect from the power supply,

remove the guard and wipe the reflector and elements with a clean damp

cloth. DO NOT use abrasive cleaners. Take care that no moisture enters the

heater.

• Refer to your CLARKE dealer if internal maintenance is required.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]