Clarke DEVIL 370SPD Operating & Maintenance Instructions - Page 12
Browse online or download pdf Operating & Maintenance Instructions for Heater Clarke DEVIL 370SPD. Clarke DEVIL 370SPD 17 pages. Quartz halogen heater
Print Page
FAULT FINDING
SYMPTOM
Heater does not
operate, although
plugged in and
switched on.
Heater tube is glowing
hot.
Heater does not
respond to remote
controller.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PROBLEM
Plug is loose/bad
connection.
Fuse blown.
No power at socket
outlet.
Tilt safety switch is
disabling unit.
Input voltage incorrect. Ensure power supply
Air supply obstructed.
Batteries defective.
Controller is out of
range or not pointing
at the receiver.
Controller damaged
internally
12
SOLUTION
Remove the plug & check
the connection of the plug
and socket.
Replace if necessary and
investigate the cause. If
fuse blows repeatedly,
consult your CLARKE
dealer.
Insert plug into a suitable
socket.
Ensure unit is upright. If
switch does not re-set,
consult your CLARKE
dealer.
matches the rating on the
label.
Ensure the heater is kept
away from any objects or
materials which could
obstruct the flow of air.
Replace batteries.
Move closer or try different
angles of pointing the
controller at the heater.
Consult your CLARKE
dealer.