Clarke Devil 6009 Operating And Maintenance Instructions Manual - Page 10
Browse online or download pdf Operating And Maintenance Instructions Manual for Heater Clarke Devil 6009. Clarke Devil 6009 20 pages. Electric fan heaters
Also for Clarke Devil 6009: Operating And Maintenance Instructions Manual (20 pages)
Print Page
3-position fan speed /
temperature contro
The thermal cutout may also operate if the heater is shut down without
allowing to cool sufficiently. If subsequently, the heater fails to start, press the
RESET using a suitable tool and try again.
MAINTENANCE
If the heater has been used, ALWAYS allow it to cool down for at least 10
minutes (by switching the heater off, but leave the fan running), then
disconnect from the mains supply before performing any maintenance tasks.
PERIODICALLY
• Disconnect from the mains supply, and use compressed air to clean
out the unit. ALWAYS wear a dust mask to perform this operation.
• If there is any serious build up of dirt, wipe thoroughly with a damp
cloth. Take care that no moisture enters the heater.
• Inspect the mains cable for damage. Heat damage will cause the
cable to stiffen and crack. If this is found, have the cable replaced.
Check cable routing and ensure it is well away from the heat
source.
• Ensure heating elements are clear of dust (use compressed air to
clean the heater if possible).
• Avoid using solvents when cleaning plastic parts, most plastics are
susceptible to damage from various types of commercial solvents.
• Refer to your CLARKE dealer if internal maintenance is required. The
unit is fitted with tamper-proof screws to discourage users from
dismantling the heater.
• When storing the heater, allow it to cool down, then cover it with its
plastic bag and place it in its packing box for storage in a dry,
ventilated place.
l
10
Thermostatic temperature
control
Reset