Ctl Maxifuse Squeeze 63 90 125 180 SDR 11 Operating Instructions And Specifications - Page 9

Browse online or download pdf Operating Instructions And Specifications for Tools Ctl Maxifuse Squeeze 63 90 125 180 SDR 11. Ctl Maxifuse Squeeze 63 90 125 180 SDR 11 18 pages. Hydraulic-style squeeze off tool

Print Page

8. A single squeeze tool cannot be guaranteed to provide 100%

closure, where this is required users are advised to consider

using 2 squeeze tools.

Instructions for use.

Fitting

1) Unscrew the 2 check screws until the threads are clear of the

threaded blocks.

2) Locate the pressure control valve on the hydraulic jack. The

tip of the jack handle will connect onto this. Unscrew the

control valve until any internal pressure in the jack is

released. The jack and squeeze bar assembly will be

retracted under the pressure of the return springs.

3) Remove the Bottom bar from the loops in the mainframe

4) Set the limit stop (buffer) plates to the correct pipe diameter

and rating (SDR) of the pipe to be squeezed. If the plates do

not have the correct sizes, check the other set exchange if

necessary. The plates are set correctly when the correct end

face is pointing downwards and positioned to contact the

bottom bar when this is re-fitted.

5) Position the mainframe over the pipe to be squeezed and

slide the bottom bar into the loops of the mainframe beneath

the pipe, position the pipe centrally between the squeeze bar

and bottom bar.

6) Close the pressure control valve by screwing clockwise with

the jack handle.

7) Fit the jack handle into the collar of the pump on the jack.

Commence pumping the jack to apply the squeeze pressure.