CTM LYNG Microsafe mKomfy Hybrid R-T Installation Instructions Manual - Page 13

Browse online or download pdf Installation Instructions Manual for Cookers CTM LYNG Microsafe mKomfy Hybrid R-T. CTM LYNG Microsafe mKomfy Hybrid R-T 16 pages. Cooker guard
Also for CTM LYNG Microsafe mKomfy Hybrid R-T: User Instructions (2 pages)

Print Page
DIP 9: Autoconnect
Fifteen minutes after turning the
cooker off, the cooker guard will
automatically be reset and turn
the power back on. On a cooker
with rotary switches, all the
rings and oven must be turned off before the cooker guard will reset itself
automatically.
If this function is deactivated or to reset the cooker guard manually, press the
control button on the sensor (or external switch panel, optional extra).
DIP 0: Test mode / Function test
There are three different function tests:
1 = On/Off test
3 = Temp. test
To activate the function test:
1.
Remove the SENSOR cover and set DIP switch 0 to ON
2.
Put the cover back on temporarily to stop the batteries falling out.
To change between the three function tests, hold the control button on the
sensor in for 5 seconds. The sensor acknowledges with one, two or three
beeps to indicate the test type.
1 beep
On/Off test
The sensor acts as an ON/OFF switch.
Pressing the control button switches between turning the power to the
cooker ON/OFF. The light on the sensor comes on when the relay is on
(sending power to the cooker).
2 beeps
Current test
Indicates electricity consumption
for the hob.
Following activation turn the hob
on. A few seconds later the LED
on the SENSOR should come on
continuously and the green and
yellow LEDs on the RELAY should
light up.
Now turn the hob off. The LED on
the SENSOR goes out and only the
GREEN LED on the RELAY should
be on.
When you have performed the function test(s), remember to set
DIP switch 0 to OFF.
2 = Current test
Installation – Settings
DIP 9
Autoconnect
OFF
Autoconnect off
ON
DIP 0
Test mode
OFF
ON
Test mode on
3 beeps
Temperature test
Turns the cooker on/off based on
temperature.
•
Point the sensor at a hot
surface/object. The cooker
turns off if the temperature
is over 35°C.
•
Point the temperature at
a cold surface (at normal
room temperature). The
cooker comes back on if the
temperature is below 35°C.
De-
fault
De-
fault
13