CLAS OM 0617 Manual - Page 3

Browse online or download pdf Manual for Tools CLAS OM 0617. CLAS OM 0617 4 pages. Clutch alignment tool

Print Page
CLAS OM 0617 Manual
OM 0617
CLUTCH ALIGNMENT TOOL
WARNING
Please read these instructions carefully. note the safe operational requirements, warnings and cautions. use the
product correctly and with care for the purpose for which it is intended. failure to do so may cause damage and/
or personal injury and will invalidate the warranty. please keep instructions safe for future use.
SAFETY INSTRUCTIONS
WARNING! Ensure that Health and Safety, local authority and general workshop practice regulations are adhered
to when using this product.
DO NOT use this product if damaged.
Maintain product in good condition for best and safest performance.
Ensure that the ignition key is removed, to prevent inadvertent engine cranking.
If the vehicle to be worked on is raised, ensure that it is adequately supported with axle stands or ramps and
chocks.
Wear suitable clothing to avoid snagging. Do not wear loose jewellery and tie back long hair.
Account for all tools and parts being used.
If working off the vehicle, ensure that the workpiece is secure and stable.
DO NOT use the alignment tool if you are tired or under the in uence of alcohol, drugs or intoxicating medication.
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or a proprietary manual, to establish
the current procedure and data. These instructions are provided as a guide only.
APPLICATIONS
Audi, Citroen, Fiat, Ford, Honda, Mazda, Mitsubishi,
Nissan, Opel, Peugeot, Renault, Rover, Saab, Toyota,
Vauxhall, VW and Volvo.
CONTENTS
Alignment Adaptor Bar
Centring Sleeves, Numbers 1 - 8 (Ø10.6-20mm)
Guide Sleeves, Numbers 1 - 8 (Ø13.7-26mm)
INSTRUCTIONS
1. Select the appropriate guide sleeve for the internal diameter of clutch plate and slide it onto the alignment
adaptor bar. Ensure the taper of the guide sleeve runs towards the threaded end of the adaptor bar.
2. Select the appropriate centring sleeve for the spigot bearing and screw it onto the end of the alignment adaptor
bar.
3. Slide the clutch plate onto the guide sleeve, ensuring the correct orientation.
4. Fit the centring sleeve into the spigot bearing and slide the clutch plate, on the guide sleeve, up to the ywheel.
5. Fit the clutch pressure plate and cover assembly and bolt in place.
6. Remove the alignment tool.