Lenovo TAB 4 User Manual - Page 14
Browse online or download pdf User Manual for Tablet Lenovo TAB 4. Lenovo TAB 4 20 pages. 8"
Also for Lenovo TAB 4: User Manual (26 pages), Safety, Warranty & Quick Start Manual (13 pages)
Print Page
Information About Multilink PPP Support for Cisco ASR 1000 Series Routers
here, you must also define a QoS policy with one or more priority classes, and attach the QoS to this
interface using the service-policy output policy-map name command. This command classifies the
priority traffic, that is interleaved by the MLP.
See the QoS and LFI configuration examples in the "Configuring Multilink PPP Connections" chapter
in the
1000).
When configuring MLP fragmentation on the various Cisco platforms, the functionality of MLP
fragmentation and interleaving support on the various platforms may differ. This section explains the
configuration options and their interpretation in the context of the Cisco ASR 1000 Series Aggregation
Services Routers.
Based on the values of the MLP fragmentation configuration commands, the MLP feature calculates two
values that are used during MLP fragmentation: link weight and maximum fragment size. These
parameters are calculated for each member link in the bundle.
First, a link weight must be determined for each member link. The link weight indicates the number of
bytes, and the MLP uses this value to balance the data amongst the links in the bundle. This parameter
is especially important when the links in a bundle are of unequal bandwidth. The link weight is based on
a combination of the bandwidth of the member link and the PPP multilink fragment delay value. If you
do not configure the fragment delay value, a default delay value of 30 milliseconds is used:
Link Weight = (Member Link Interface Bandwidth in bps/8) * Fragment Delay
Caution
Configuring the fragment delay to a smaller value results in smaller fragment size because the fragment
delay value determines the default fragment size on the member link. This, in turn, implies loss of
bandwidth due to the added Layer 2 header overhead. This is important for broadband MLP, which can
have Layer 2 headers of 4 to 58 bytes in length.
The default maximum fragment size must be calculated per member link. The default maximum
fragment size used will be the lesser value obtained from either of the following calculations:
•
•
After the default maximum fragment size is calculated, if you have configured the ppp multilink
fragment size (maximum) command at the multilink, virtual template, or serial interface level, the
default maximum fragment size is compared against the configured maximum value and is capped
accordingly. If the fragment size is configured at the serial interface level and the multilink interface
level, the serial interface configuration takes precedence.
MLP Fragmentation Model
Earlier, some Cisco platforms supported a legacy MLP fragmentation model that was enabled by default
if all the following criteria were met:
•
•
•
Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide
11-14
Wide-Area Networking Configuration Guide: Multilink PPP, Cisco IOS XE Release 3S (Cisco ASR
Link Weight – Multilink PPP + PPP Header Overhead (8)
Interface MTU – Multilink PPP Header Overhead (4)
Two or more active member links exist in the bundle.
All the member links have equal bandwidth.
No other form of multilink fragmentation or interleave commands are configured on the bundle or
member-link interface.
Chapter 11
Multilink PPP Support for the Cisco ASR 1000 Series Routers
OL-16506-17