Nikon DS-Qi1Mc Instructions Manual - Page 16
Browse online or download pdf Instructions Manual for Camera Accessories Nikon DS-Qi1Mc. Nikon DS-Qi1Mc 49 pages. Ds camera control unit/camera heads
Also for Nikon DS-Qi1Mc: Instructions Manual (49 pages)
Print Page
Chapter 4
Connecting and Installing the Equipment
2
Installing the DS-U2
Installing the DS-U2
2
The DS-U2 can be positioned either horizontally or vertically.
• Horizontal installation
Set the DS-U2 horizontally on a flat surface.
Provide a clearance of approximately 100 mm around the product to dissipate heat.
• Vertical installation
Attach the vertical stand to the DS-U2 for setting the product in the vertical position.
Set the DS-U2 vertically on a flat surface as shown below.
Provide a clearance of approximately 100 mm around the product to dissipate heat.
Attach the vertical stand as follows:
Remove the two screws at the upper front position and the lower rear position among four screws
on the right side of the DS-U2. (See Figure A below.)
Then, fix the stand to the right surface of the DS-U2 using the removed screws. (See Figure B
below.)
Use an M2.5-size Phillips driver to attach or detach screws.
Figure A
Figure B
- 10 -