Nikon WR-R10 Quick Start Manual

Browse online or download pdf Quick Start Manual for Camera Accessories Nikon WR-R10. Nikon WR-R10 6 pages. Wireless remote controller/wr adapter
Also for Nikon WR-R10: User Manual (2 pages), User Manual (2 pages), Manual (6 pages), User Manual (6 pages)

Print Page

Updating the Firmware for WR-1/WR-R10

Wireless Remote Controllers

Thank you for choosing a Nikon product. This guide describes how to update the firmware

for WR-1 and WR-R10 wireless remote controllers. If you are not confident that you can

perform the update successfully, the update can be performed by a Nikon-authorized service

representative.

See the manual provided with your Nikon product for information on use.

Important

The product may be damaged if power is interrupted or the controls are operated during

the update. Do not turn the product off, remove or disconnect the power source, or attempt

to operate the product during the update. If the update is not completed successfully and

the product becomes inoperable, take it to a Nikon-authorized service representative for

inspection.

Get ready

To perform the update, you will need:

• Either

— A WR-1 wireless remote controller and supplied cable (either a ten-pin or

accessory terminal cable, depending on the camera) or

— A WR-R10 wireless remote controller (if the camera is equipped with a ten-

pin terminal, you will also require a WR-A10 WR adapter)

• A camera that can be used to update the wireless remote controller firmware

(a D7100 is used in this guide for illustrative purposes)

• A computer equipped with a card reader or card slot

• One of the following camera power sources:

— An AC adapter

— A fully-charged battery

• A Nikon-approved memory card that has been formatted in the camera (note

that all data on the memory card will be deleted when the card is formatted;

before formatting the card, back up any data you wish to keep to a computer

or other device)

• The manuals for the camera and wireless remote controller

Mac

– Mac –