Cub VS-95A042 Operation Manual - Page 11
Browse online or download pdf Operation Manual for Automobile Accessories Cub VS-95A042. Cub VS-95A042 12 pages. Rv blind spot detection system
Print Page
9. TROUBLESHOOTING
ISSUE
SYMPTOM
The system does not
respond after starting
the engine
The indicator does not
light up
Power On
Self-test
The buzzer makes no
sound
The power switch
does not work
[ Do Re Mi ] alarm
System
Operation
Did not enter sleep
mode after 5 minutes of
IGN off
No Level 1 BSD alert
Functions
No Level 2 BSD alert
No RCTA alert
POSSIBLE CAUSE
Incorrect connection or
control unit failure
Damaged indicator
Disconnected indicator
Damaged buzzer
Disconnected buzzer
Damaged power switch
Disconnected power
switch
Radar disconnection or
no OBD connection
IGN lead connected
to constant power
Vehicle speed is less
than 12 mph
Bad connection from
OBDII
Turn signal leads not
connected
Reverse lead not
connected
RV BLIND SPOT DETECTION SYSTEM: For Motorhomes | 7
POSSIBLE SOLUTION
Confirm that the IGN,
wiring, fuse, and
controller are connected.
Contact your dealer
Verify connection
Contact your dealer
Verify connection
Contact your dealer
Verify connection, press and
hold the switch for 2 seconds.
Abnormal power supply,
wiring, or radar, please
contact your dealer.
Change the IGN to a switched
power source connection
location
Normal operation
The vehicle is not compatible.
Please contact the dealer.
Press the RESET button on
the control unit after starting
the engine. Check the system
again after the reboot is
completed.
Confirm turn signal leads are
connected
Confirm that the reverse lead
is connected