Dirt Devil F90 Owner's Manual - Page 9
Browse online or download pdf Owner's Manual for Vacuum Cleaner Dirt Devil F90. Dirt Devil F90 14 pages.
TROUBLESHOOTING GUIDE
WARNING: TO REDUCE RISK OF PERSONAL INJURY - UNPLUG BEFORE CLEANING OR SERVICING
PROBLEM
POSSIBLE REASON
Cleaner won't run 1. Power cord not firmly plugged into
outlet.
2. Blown fuse or tripped breaker.
3. Needs service.
4. Thermal Protector activated.
Cleaner won't
1. Dirt container not installed
pick
correctly.
up or low suction
2. Dirt container full.
3. One or both filters are clogged.
4. Variable speed control is set too
low.
5. Nozzle/Brushroll clogged.
Dust escaping
1. Dirt container full.
from cleaner
2. Dirt container not installed
correctly.
3. Hose not installed correctly.
4. Filter not installed correctly.
Cleaner tools
1. Hose clogged.
won't pick-up
2. Dirt container full.
3. One or both filters are clogged.
ANY OTHER SERVICING SHOULD BE DONE BY AN AUTHORIZED
SERVICE REPRESENTATIVE.
IF APPLIANCE IS NOT WORKING AS IT SHOULD, HAS BEEN DROPPED,
DAMAGED, LEFT OUTDOORS, OR DROPPED INTO WATER, TAKE IT TO A SERVICE
CENTER PRIOR TO CONTINUING USE.
CUSTOMER SERVICE (1-800-321-1134)
In the event that further assistance is required, see your Yellow Pages for an authorized Royal
transportation to and from any place of repair are to be paid by the owner. The service parts used in this unit are
easily replaced and readily available from an authorized Royal
the model number and manufacturing code when requesting information or ordering replacement parts. (The model
number appears on the bottom of the cleaner.)
STORAGE
BEFORE STORING CLEANER:
1. Turn unit off. Unplug.
2. To return cord for storage, hold plug and press down cord release pedal on side of cord reel.
3. Place tools in tool storage located under handle grip.
4. Collapse extension wands and place them into the storage wand clip.
POSSIBLE SOLUTION
1. Plug unit in firmly.
2. Check fuse or breaker in home. Replace fuse/
reset breaker.
3. Take to service center or call 1-800-321-1134.
4. Unplug unit and allow to cool for 30 minutes.
1. Review dirt container removal and replacement.
2. Empty dirt container.
3. Remove both filters and clean.
4. Adjust variable suction control.
5. Check nozzle/brushroll; remove obstruction/clog.
1. Empty dirt container.
2. Review dirt container removal & replacement.
3. Review hose installation.
4. Review filter removal & replacement.
1. Remove hose and tools; remove obstruction.
2. Empty dirt container.
3. Remove both filters and clean.
Dealer. Costs of any
®
Dealer or retailer. Always identify your cleaner by
®
9