Acorn Safety S0860-LH Installation, Operation And Maintenance Instructions - Page 3

Browse online or download pdf Installation, Operation And Maintenance Instructions for Washer Acorn Safety S0860-LH. Acorn Safety S0860-LH 5 pages. Eyewash/facewash

Print Page
Installation & Operation Manual

INSTALLATION INSTRUCTIONS:

Supplies required: (not provided by Acorn)
1. Wall/deck mounting hardware to install assembly.
2. Wall fasteners for sign mounting.
3. Pipe sealant or Teflon tape for sealing water connections.
IMPORTANT: FLUSH SUPPLY LINES PRIOR TO
CONNECTING TO SAFETY EQUIPMENT.
NOTES:
Top of spray nozzles must be between 33" - 45" from
Ÿ
finished floor in order to meet ANSI Z358.1. See page 2.
Refer to Rough-in for location of supply and drain lines.
Ÿ
Fragments of Teflon tape or pipe sealant residue can
Ÿ
interfere with the proper operation of this unit. Ensure pipe
sealant methods do not cause contamination in the
system.
STEP ONE: MOUNTING
A. Remove (2) #8 screws and mounting cover.
B. Position assembly on deck allowing clearance for spray
heads when unit is in up position (Models: S0660-LH,
S0660-RH, S0850-LH & S0850-RH). Alternatively, position
assembly on wall allowing clearance for arm when unit is
in down in the down position (Models: S0650-LH, S0650-
RH, S0660-LH & S0660-RH).
C. While holding bracket in appropriate location and
alignment, mark 4 mounting hole locations.
D. Make appropriate preparations for mounting hardware.
E. Re-position assembly and install using hardware
(supplied by others).
STEP TWO: SUPPLY LINE
F. Install water line (supplied by others) in a position to align
with 1/2" strainer.
G. Open water supply.
H. Test for leaks, proper operation and flow.
I. Make appropriate preparations for mounting hardware.
STEP THREE: FINAL ASSEMBLY
J. Re-position mounting cover onto assembly.
K. Secure cover using (2) #8 screws removed above.
STEP FOUR: SIGNAGE & INSPECTION
L. Position sign with clear visibility, in close proximity to
safety equipment and mark mounting hole locations.
M. Select appropriate 1/4" anchors, screws and washers
(supplied by others) to install signage.
N. Attach inspection tag supplied with plastic zip tie. ANSI
Acorn Safety
a division of Acorn Engineering Company™
Manual #7109-400-001
#8 SCREWS

SUPPLY LINE

(SUPPLIED BY OTHERS)
SUPPLY LINE
(SUPPLIED
BY OTHERS)
Page 3 of 5

MOUNTING COVER

DETAIL "A"
Revised: 01/07/2013