Blade mCP X Instruction Manual - Page 11

Browse online or download pdf Instruction Manual for Toy Blade mCP X. Blade mCP X 18 pages.
Also for Blade mCP X: Instruction Manual (20 pages)

Print Page

Troubleshooting Guide

Problem

Helicopter will not

initialize

Helicopter will not

spool up

during flight

Cannot turn off

throttle hold

Powers off when flying

Will not bind properly to

non-computer radio

Poor tail authority

Climb out rate is greatly

reduced

rapidly and aircraft will

Helicopter vibrates or

Possible Cause

Throttle at high position

Pitch or throttle servo reversing

improperly conﬁgured

Throttle hold on

Throttle not at low position

Helicopter binds differently to

non-computer radios

The tail rotor blade is warped

or bent.

shaft.

powering transmitter and before

Transmitter too near aircraft

during binding process

Aircraft not bound to transmitter

Aircraft bound to different model

batteries

Damaged rotor blades, spindle or

blade grips

Solution

throttle trim at center or lowest setting

hold.

Reset servo reversing

Refer to "Programming your Transmitter"

centered or low.

Refer to "Throttle Hold"

Recharge flight battery or replace battery

that is no longer performing

hold.

throttle trim at center or lowest setting

before flying inverted.

Release bind button/ switch after

applying left rudder. Do not hold the bind

button/ switch after applying left rudder.

Replace tail boom

or replace.

battery to aircraft

feet from aircraft, disconnect and

Bind transmitter to aircraft receiver

transmitter

Replace or charge transmitter

batteries

parts. Replace bent spindle.