Blade 350 QX2 Instruction Manual - Page 13

Browse online or download pdf Instruction Manual for Quadcopters Blade 350 QX2. Blade 350 QX2 18 pages.

Print Page

Activating Return Home

Switch to position 1.

Returning the switch to position 0

will stop the Return Home program.

Landing

To land the 350 QX2 AP there are two options:

• Guide the aircraft to where you wish to land and re-

duce the throttle. Hold the bind button for 1 second

after landing to disarm the motors.

• Activate the Return Home function to return the

350 QX2 AP to the assigned home location and land

automatically.

CAUTION: Do not activate the Return Home

function if the 350 QX2 AP is showing the low

battery indication. Manually land the aircraft

immediately.

Return Home

• When this feature is activated, the 350 QX2

AP will ﬂ y back to its assigned home location

and land. After landing, the motors may take

up to 5 seconds to disarm. If the motors take

more than 20+ seconds to disarm, perform

the Pressure Sensor Calibration.

• To restart the props after landing in Return Home,

fully lower the throttle, then quickly move the rudder

stick fully left and then fully right.

CAUTION: The 350 QX2 AP will not recognize

the SAFE Circle feature when Return Home

is used. Activating Return Home may cause the 350

QX2 AP to ﬂ y directly over the pilot if the aircraft was

ﬂ own to a position behind where the pilot was stand-

ing when the home position was established.

After Your Flight

1. Turn off the power switch on the 350 QX2 AP.

2. Turn off the power to your transmitter.

3. Unplug and remove the battery from the 350 QX2 AP.

CAUTION: Always disconnect the Li-Po bat-

tery from the aircraft when not ﬂ ying to avoid

over-discharging the battery. Batteries discharged to a

voltage below the lowest approved voltage may become

damaged, resulting in loss of performance and potential

ﬁ re when batteries are charged.

Location alert

The motors will beep under the following conditions:

• At any time the props stop spinning after they have

been initialized.

• After 30 seconds of no throttle input (waiting armed

on the ground).

This will alert the pilot to the location of the aircraft if it

lands in a location with low visibility.

Beeping will continue until the battery can no longer

supply enough power to the motors.

If the quadcopter crash lands and one or more motors

are stopped by an impact, the quadcopter enters

emergency mode. The LED will ﬂ ash white and the

motors will beep loudly.