Discount Car Stereo JAG-HF Quick Start Manual - Page 9

Browse online or download pdf Quick Start Manual for Receiver Discount Car Stereo JAG-HF. Discount Car Stereo JAG-HF 10 pages. Bluetooth kit for jaguar xk and xj with cd changer
Also for Discount Car Stereo JAG-HF: Quick Start Bluetooth Installation Manual (10 pages), Installation Manual (10 pages)

Print Page

Bluetooth operation

Turn ignition to ACC position and radio ON.
1.
Press "CD" button on radio. Track or Disc number displayed only if they are
2.
disc in magazine otherwise "NO MAGAZINE" is displayed (See Fig. 27)
Radio must be in "CD Mode" when using the JAG-HF.
connected but will no longer play.
Use radio button to adjust playback level and tone controls.
3.
Music Commands
To
Pause a Song
Resume Play
Skip to next song
Skip to Previous Song
Activate Aux input*
Activate Voice Control
Switch from Aux to Streaming Audio
Fig. 27
CD Changer remains
Proceed this way
Press and release button
Press and release button
Press button twice
Press button three times
Press button four times
Press/hold button for 2 seconds
Press and release button

Phone Commands

To
Answer call
End call
Reject incoming call
Cancel outgoing call
Activate Voice Control
Notes:
If audio playback is distorted or low, adjust volume on phone.
1.
To reset Module, press and Hold button for 5 seconds (this will not
2.
un-pair phone or erase stored phones)
Bluetooth range is approximately 30 ft. make sure device is within
3.
range of receiver
Voice command compatible with Apple (Siri), Android (Google Now),
4.
Blackberry (Assistant)
*Audio controls not applicable in Aux mode. Use the Aux device built-in
5.
control for music selection and controls.
If successful proceed to reverse the removal steps for Amp rack and center
glovebox console and secure the control button/microphone to dash as per step
#6 in "installing Bluetooth module" instructions.
Congratulations, you've just updated your vehicle to support new technology
while preserving the original radio and dash components.
Enjoy!
Proceed this way
Press and release button
Press and release button
Press button twice (call goes to VM)
Press button twice
Press/hold button for 2 seconds