Cub Cadet 19A40002100 Operator's Manual - Page 13

Browse online or download pdf Operator's Manual for Lawn Mower Accessories Cub Cadet 19A40002100. Cub Cadet 19A40002100 20 pages. Triple rear bagger

Print Page
Cub Cadet 19A40002100 Operator's Manual
Installing the Chute Discharge Plate
1.
Remove the discharge chute by removing the two flange
lock nuts securing it.
2.
With a hammer, lightly tap the bolts out. Discard the bolts
and flange lock nuts.
3.
Install the chute discharge plate to the bottom side of the
deck opening, as seen in Fig. 4-18, using two carriage bolts
supplied in hardware pack 689-00163.
Figure 4-18
4.
Replace the discharge chute and secure with two flange
lock nuts included in the hardware pack 689-00163.
5.
Securely tighten the hardware at this time.
Attaching Chute Stop Bracket
1.
Remove the carriage bolt and lock nut holding the chute stop
to the deck. See the left Inset of Fig. 4-19. Save the hardware.
Figure 4-19
2.
Install the new chute stop bracket, from the loose parts, at
the same position on the deck. See the right Inset of Fig.
4-19. Secure with the hardware removed earlier.
NOTE: An extra carriage bolt and lock nut have been
supplied in your bagger kit in hardware pack 689-00163.
You may replace the old hardware for the chute stop
bracket with this new hardware, or save for later use.
NOTE: This chute stop bracket may stay on the unit even
when the bagger is not being used.
Installing the Chute Strap on the Discharge Chute
Secure the strap to the chute with the hex screw (710-3015) and
flange nut (712-04064) provided In Hardware pack 689-00163.
See Fig. 20.
Figure 4-20
Installing the Discharge Chute
1.
Reinstall the cutting deck to the tractor reversing the
instructions for Deck Removal in operator's manual of the
tractor.
2.
Raise the deck to its highest position.
3.
Raise the chute deflector (A in Fig. 4-21) on the deck and
hold it while you position the discharge chute over the
chute opening.
4.
Insert the hinge pin of the discharge chute into the tube on
the chute stop bracket. See B in Fig. 4-21.
Figure 4-21
s
ectiOn
A
C
B
4 — a
& i
sseMbly
nstallatiOn
13