Cub Cadet FT 24 R Front-Tine Garden Tiller Operator's Manual - Page 15
Browse online or download pdf Operator's Manual for Lawn and Garden Equipment Cub Cadet FT 24 R Front-Tine Garden Tiller. Cub Cadet FT 24 R Front-Tine Garden Tiller 20 pages. Cub cadet ft24 r front tine tiller
Also for Cub Cadet FT 24 R Front-Tine Garden Tiller: Manual (1 pages), Brochure & Specs (2 pages)
Print Page
Service
Belt Replacement
Reverse Drive Belt
Your tiller has been engineered with a belt made of special
material (Kevlar Tensile) for longer life and better performance. It
should not be replaced with an off-the-shelf belt. Order all belts
through you authorized service dealer.
1.
Disconnect and ground the spark plug wire against the
engine.
2.
Remove the belt cover from the left side of the tiller by
removing the two self-tapping screws and hex stop nut
and washer. See Figure 7-1.
Hex Stop Nut
Self-tapping Screws
Figure 7-1
& Washer
3.
Remove belt from transmission pulley and then from
around the reverse idler pulley. See Figure 7-2.
Reverse Idler
Pulley
Engine Pulley
Figure 7-2
4.
To reassemble the new belt, follow the instructions in
reverse order. Be sure to place the wider side of the belt
against transmission and idler pulley while slimmer side
goes over the engine pulley. See Figure 7-2.
NOTE: Upon reassembly, make certain the belt is routed
over the idler pulley and inside of belt keepers by engine
pulley. See Figure 7-2.
7
Transmission
Pulley
15