3D Hobby Shop 57" Extra 330 SC Assembly Manual - Page 9

Browse online or download pdf Assembly Manual for Toy 3D Hobby Shop 57" Extra 330 SC. 3D Hobby Shop 57" Extra 330 SC 16 pages.

Print Page

Assemble elevator pushrod as shown. Use thin CA on the ball-link to pushrod joint after installation to

lock the ball-link onto the pushrod permanently. Slide carbon tube stiffener over pushrod.

Install the pushrod connectors onto the servo arms as shown. Tighten the nuts just to a snug fit – the

connector must be able to rotate after installation. Use medium CA glue on the nut to keep the connector

from falling off due to vibration. Remember – the pushrod connector must be able to rotate so that the

servo arm can move.

Remove covering over elevator horn slot and install elevator control horn into elevator as shown using a

generous amount of medium or thick CA glue. Install elevator pushrod onto horn as shown. Tighten the

ball-link to the elevator horn using a 2mm screw, washer, and nut. Once the 2mm screw and nut are

tight, use medium or thick CA glue to lock the nut in place so it cannot rotate. Make sure the 2mm screw

and nut cannot come loose in flight.