ARO 7849-E Series Operator's Manual
Browse online or download pdf Operator's Manual for Drill ARO 7849-E Series. ARO 7849-E Series 12 pages. “2200” series drills
Tool Products
OPERATOR'S MANUAL
INCLUDING: OPERATION, INSTALLATION & MAINTENANCE
SECTION
M20
MANUAL
41
Released:
W77
Revised:
1-27-95
"2200" SERIES DRILLS
Models:
7844-E, 7845-E, 7848-E-(
), 7847-E-(
),
7848-E-(
), 7849-E-(
), 7850-E, 7851-E,
7852-E, 7853-E-(
), 7854-E and 7855-E.
Form:
1166-2
READ THIS MANUAL
CAREFULLY
BEFORE INSTALLING,
OPERATING
OR SERVICING
THIS EQUIPMENT.
FAILURE TO OBSERVE
THE FOLLOWING
WARNINGS
COULD RESULT IN INJURY.
Pneumatic tools should always be installed and used in accor-
dance with A.N.S.I. 8188.1 "Safety Code for Portable Air Tools".
l
0
0
l
l
l
l
l
l
l
Operate this tool at 90 p.s.i.g. (6.2 bar) maximum air pressure
at the air inlet of the tool.
Disconnect air supply from tool before removing/installing bit,
socket or performing other maintenance procedures.
Keep hands, clothing and long hair away from rotating end of
tool.
Anticipate and be alert for sudden changes in motion during
start up and operation of any power tool.
Never exceed rated r.p.m. of tool.
Wear suitable eye and hearing protection while operating tool.
Tool shaft can continue to rotate briefly after throttle is re-
leased.
Do not lubricate tools with flammable or volatile liquids such as
kerosene, diesel or jet fuel.
Do not remove any labels. Replace any damaged label.
Use only accessories recommended by ARO.
Repeated prolonged operator exposure to vibrations which may
be generated in the use of certain hand-held tools may produce
Raynaud's phenomenon, commonly referred to as Whitefinger
disease. The phenomenon produces numbness and burning
sensations in the hand and may cause circulation and nerve dam-
age as well as tissue necrosis. Repetitive users of hand-held
tools who experience vibrations should closely monitor duration
of use and their physical condition.
l
The use of other than genuine ARO replacement parts may
result in safety hazards, decreased tool performance and in-
creased maintenance and may invalidate all warranties.
l
ARO is not responsible for customer modification of tools for
applications on which ARO was not consulted.
l
Tool maintenance and repair should be performed by autho-
rized, trained, competent personnel. Consult your nearest
ARO authorized servicenter.
l
It is the responsibility of the employer to place the information
in this manual into the hands of the operator.
For parts and service information, contact your local ARO distributor, or the Customer Service Dept. of the Ingersoll-Rand Distribution
Center, White House, TN at PH: (615) 672-0321, FAX: (615) 672-0601.
ARO Tool Products
Ingersoll-Rand
Company
1725 U.S. No. 1 North
l
PO. Box 8000
l
Southern Pines, NC 28388-8000
©1995 THE ARO CORPORATION.
PRINTED
IN U.S.A.
Part of worldwide Ingersoll-Rand