3D Hobby Shop YAK55 Assembly Manual - Page 19
Browse online or download pdf Assembly Manual for Toy 3D Hobby Shop YAK55. 3D Hobby Shop YAK55 19 pages.
SETUP INFORMATION
Center of Gravity
The recommended Center of Gravity range is 2.75 to 3.25 inches from the leading edge of the wing root. For maiden
flight, the plane should ideally have the Center of Gravity at the designer recommended 2.75 inches. After several
flights, you can and should adjust to find your perfect, personal CG location.
Control throws
Low / Precision Rates (in degrees and inches) and Corresponding Exponential
Aileron
15 degrees
Elevator
10 degrees
Rudder
20 degrees
High / 3D Rates (in degrees and inches) and Corresponding Exponential
Aileron
35 degrees
Elevator
45 degrees or more
Rudder
45 degrees
Note: that Hitec and Futaba radios require NEGATIVE exponential, while JR and Spektrum use POSITIVE exponential.
Servo arm length:
Most servo arms have multiple locations in which you can install your pushrod adjustors into, giving different effective
servo arm lengths. The method to determine the correct hole is as follows:
Set your high-rate throws as indicated above using the endpoint adjustment for each channel in your transmitter. If your
endpoint adjustment is near maximum (a value of 140-150 on most transmitters) then you are using the correct hole.
However, if your endpoint adjustment is much lower, under 125 for example, you may need to use a hole that gives a
shorter effective arm length. If your endpoint adjustment for correct high-rate throws is excessively low, you will notice
very poor servo performance.
To put it simply, use the shortest arm length that still allows proper high rate throws. Once you are certain of the correct
arm length, be sure to use thick CA to lock all of your adjustor nuts on all servo arms.
Again, if you have any issues, questions, concerns or problems during assembly, please contact our tech
department at:
We highly recommend
20% expo
20% expo
30% expo
75% expo
75% expo
75% expo
Enjoy Your 3DHS Yak55!
or 1-717-814-5316 10am-4pm Eastern Time, Monday-Thursday.
www.RCGroups.com
as a good source for RC tips, tricks, and information.