Cubic casja80l Instruction Manual - Page 6

Browse online or download pdf Instruction Manual for Pet Care Product Cubic casja80l. Cubic casja80l 15 pages. Jellyfish aquarium

Print Page

Fig.2

MEDIA TUBE

Once filled and flushed, the media tower should be

inserted into the rear compartment

into its seat at the bottom of the chamber. This is a simple

locking system requiring alignment of the 3 tabs on each

face to interlock, afterwards apply a gentle twist with

downward pressure to lock the media tower into place

against its O-ring seal

(Fig3:

circumstances should the fitting be forced or over-tight-

ened. Apply only a gentle twisting action with slight

downward pressure until the unit feels secure in its seat.

CIRCULATION PUMP

Once the media tower is in place, Attach the outlet of the

circulation pump onto the fitting supplied on the lid of the

media tower,

(Fig2: D)

the lid should then be inserted into

the top of the media tower, ensuring it is firmly seated

against its O-ring

seal

(Fig3: C).

circulation pump is an adjustable grill that controls the

amount of flow produced. Set this to 'minimum' initially.

(Fig2: C)

(Fig3: B)

and located

A). IMPORTANT: Under no

On the front face of the

MEDIA TOWER LID

Take the cylindrical media tower

(Fig2: B)

and remove the lid by pulling it gently upwards

(Fig2: A)

The lid seals with an O-ring that sits in a grove

around the edge of the lid flange.

FILTER MEDIA

Fill the media tower with a suitable 'marine' applicable

media such as very course (>8mm) coral gravel,

artificial bio media such as porous ceramics, or for

best results, use lightly crushed course live-rock rubble

which will act as a good biological filter with the

additional benefit of host micro-fauna. If a non-bacteri-

ally live media is used, it is recommended that it is

'seeded' biologically by mixing in a small amount of live

rock rubble from your marine aquatic retailor or by the

use of a proprietary maturation fluid. After filling the

Media tower, flush several times with salt water to

wash out any fine sediment or particulates that may

otherwise be passed into the aquarium on start-up.

IMPORTANT:

We do not recommend using a bio media with particles

that are smaller than 8mm. These can block the holes

in the bottom of the media tube causing pressure to

build up which can force the lid to come off.

Fig.3

page