3D innovations DeskCycle Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Home Gym 3D innovations DeskCycle. 3D innovations DeskCycle 12 pages. Using the large display manual
Also for 3D innovations DeskCycle: User Manual (16 pages), Manual (3 pages)

Print Page

Using the Velcro® Tether with Rolling Chairs

The DeskCycle™ comes with a long Velcro strap that can be used to tether the bike to the

chair as shown in the picture below. The strap is made from Velcro Loop material.

On the back side of one end is Velcro Hook material.

Do I need the Tether?

Most people don't need the tether. Pedaling the bike downward will keep it in place. The tether

may be needed if you use a rolling chair on a smooth surface. In this case the tether keeps the

chair from rolling away from the bike.

Installation:

1. Position the bike in front of the chair.

2. Sit in your chair and pedal the bike. Your knees should be bent about 25 degrees from

fully-extended when the pedal is farthest away from you.

3. Route the Velcro strap as shown in the picture below. Keep the strap as low as

possible. Stretch the loop tight and attach the end with the Hook material to the Loop

material to make a tight loop.

4. Pedal the bike to make sure the distance is correct. Adjust if necessary.

5. With a pair of scissors, cut away the excess Velcro strap. This will make it easy to

create the same size loop later.

Important!

You may want to remove the tether when not using the bike to prevent a tripping hazard!