Dish Network VideoPath DishPro 21 Installation Manual - Page 5
Browse online or download pdf Installation Manual for Remote Control Dish Network VideoPath DishPro 21. Dish Network VideoPath DishPro 21 19 pages. Multi-dish switch
Print Page
How to Install a DP21 Switch
The following instructions assume you have already
pointed your dish for the strongest possible signal, that you
have run Check Switch with the DishPro LNBF
connected directly to the receiver's Satellite In port, and
that you have taken a software upgrade from the satellite. If
not, follow the Dish installation instructions that came with
your receiver.
Connections
1.
Mount the DP21 switch onto the side of a building, or on some
other sturdy structure. Make sure that the switch is mounted with
the port labeled To Receiver Satellite In pointing down. Fasten
the switch tightly to the surface.
Note: The DP21 switch is designed for outside use
You can have up to 200 feet of RG-6 cable between a
DishPro LNBF and a DishPro satellite receiver with the
DP21 Switch connected at any point along the 200 feet of
RG-6 cable. The cable must be RG-6 or Series 6 and
marked for use at 2200MHz or higher. If you are unsure
contact your local DISH Network retailer, or DISH
Network at 1-800-333-DISH (3473) to arrange for a
professional installation. Use of the incorrect type of
cable may affect system operation or performance.
.
5