CubuSynth Engine Build Manual - Page 4

Browse online or download pdf Build Manual for Music Equipment CubuSynth Engine. CubuSynth Engine 20 pages. Dual complex vco with wave shaping and modulation features

Print Page

CubuSynth Engine - Build Guide

PCB V1.1 May 2022

BUILD GUIDE

STEP 1 (Switch PCB)

Take the small Switch adapter PCB and the 4 position slide switch. Place the switch on the side

that says SW3. It is recommended to use a helping hand to secure them together while soldering.

When soldered, cut the solder legs flush with the PCB to avoid shorting them later!

Then put it aside for later use.

STEP 2 (Main PCB)

Resistors

There is several ways to go, you might already have developed your own method to place

components and solder.

You can always select the resistors of the same value, place them, turn the board around and

solder in place. Trim the solder legs and move on to the next value.

Another method is to place all resistors and solder them from the top, without turning around

the board.

On the next page, you can find the list of resistors needed for the main PCB and a picture of all

resistors in place.

To help keep track of the already placed components, you can print the BOM and cross out the

parts you already soldered.

For the "10R/Bead" you can either use Ferrite Beads or 10R resistors.

Page 4