ARP Fridge Defend User Instructions - Page 10

Browse online or download pdf User Instructions for Automobile Accessories ARP Fridge Defend. ARP Fridge Defend 17 pages. V5 + fan control
Also for ARP Fridge Defend: User Manual (10 pages)

Print Page
ARP Control v5.x

Turn ON Control in SetUp Mode

Before the
SetUp
mode can be started, the ARP Control must be turned off, see section above
titled
ON/OFF BUTTON – Turn On/Off ARP
ARP BUTTON
TURN ON
CONTROL
In SetUp Mode
START by
holding the SetUp
Button
NEXT
Momentary press On/Off Button.
Release SetUp Button
☻

Before Contacting ARP for Assistance

Please record the first 7 values identified with the '
before contacting ARP for help with any troubleshooting needs:
1. AtO: Tells operator or diagnostician which control mode.
2. AtS: Gives further info on control mode.
3. AbS: Maximum temperature boiler has reached.
4. tr:
Number of times a trip or boiler overheat has occurred.
5. OPn: Number of times open circuit is recorded for boiler sensor purple/white wire.
6. SHt: Number of times short circuit is recorded for boiler sensor purple/white wire.
7.
SSH:
If the control is in the C-L or C-H mode, this value will be fixed as '-L0'.
If the control is in the PID mode, this will record the maximum steady-state
temperature.
Graphical User Instructions 04/20/2020 © ARPC L.L.C. All rights reserved.
ARP DISPLAY
C-H is the default value unless
the Control Mode has been
changed. See the AtO Reading
in Troubleshooting Guide.
Control.
☻
' symbol found in the SetUp Mode below
FURTHER INFORMATION
About the only time SetUp will
be needed is for reading of the
stored variables for
troubleshooting. Or, upon initial
installation if your fridge
is one of the refrigerators listed
that require the PID mode the
SetUp Mode will be needed for
changing the setting.
In addition to this guide,
the User Guide and the
Troubleshooting Guide gives
detailed information on how to
use the SetUp Mode.
Please scan the respective
manuals Table of Contents for
the desired operation.
The first variable seen in the
SetUp mode is 'AtO'. The
display will flash between the
variable name 'AtO' and the
'AtO' value. Please see next
section for Navigating the
SetUp Mode.
10