Dispense-Rite SLR-2F-CSD Installation Instructions
Browse online or download pdf Installation Instructions for Dispenser Dispense-Rite SLR-2F-CSD. Dispense-Rite SLR-2F-CSD 2 pages.
Print Page
DISPENSE-RITE
INSTALLATION & BAFFLE SELECTION INSTRUCTIONS
The cup dispenser is completely assembled but will require the proper size silicone rubber baffle be inserted once the
dispenser has been installed. A full sleeve of cups is recommended for dispenser installation and baffle selection.
The SLR-2F-CSD model is a single spring (light) model and is intended for use with paper, plastic or foam cups in
horizontal mounting positions. This model may also be used vertically with foam cups. If the dispenser will be used
in a vertical or angled position with paper or plastic cups a heavier spring (not included) must be ordered separately.
SECTION ONE - CUP DISPENSER INSTALLATION
Cut a 5-1/4" diameter hole into the desired
1
mounting surface.
Rotate the cover ring counterclockwise and
2
remove from the dispenser. Remove the
cardboard spacer insert and discard.
3
5
"
5-1/4"
16
132 mm
134 mm
Diversified Metal Products, Inc.
2205 Carlson Drive • Northbrook, IL 60062 • (847) 753-9595 • fax (847) 753-9648
www.dispense-rite.com • [email protected]
®
Model: SLR-2F-CSD
3. Insert the dispenser into the mounting hole.
3
Align the "UP" mark to the top in a horizontal or
angled application and to the rear in a vertical
mounting application.
4. Drill four 9/64" pilot holes in the locations shown
4
below. Fasten the dispenser with the four #10
screws provided.