3D Systems ProJet 1200 Quick Setup Manual

Browse online or download pdf Quick Setup Manual for 3D Printers 3D Systems ProJet 1200. 3D Systems ProJet 1200 2 pages.

Print Page
ProJet 1200™ Setup
Please refer to the ProJet1200 User Guide for safety and comprehensive operating instructions. You can find the ProJet 1200 User Guide on 3DSCentral.com.
SAVE ALL FOAM AND PACKING MATERIAL FOR FUTURE USE. SHIPPING WITHOUT THE ORIGINAL PACKING MATERIAL MAY CAUSE DAMAGE TO THE PRINTER.
A
Open the box
Remove the peripherals box
Lift off the peripherals box (A) and place it
Pull the tabs on both release clips (A), one
to the side.
on each side. Remove the clips from the
outer box by pulling them out. Lift the
outer box off the printer.
B
A
Remove Insert
Install print platform
1.
Rotate the print platform clamp lever
Open the print door and pull up the
upward.
cartridge clamp lever (A) and remove
the plastic insert (B) from the material
cartridge support.
A
B
D
C
Remove the upper foam
support
Remove the upper foam support (B).
Carefully lift machine out of box (C).
Remove the bottom foam support (D).
B
A
2.
Insert the print platform under the
clamp lever until it is seated (A).
Rotate the print platform clamp lever
down to lock the print platform (B).
A
A
Place Printer
Open peripheral boxes
Place printer in a place where there is not
Peripheral boxes contain: USB cable (A),
too much natural sunlight and it is level.
print platform (B), curing bulb (C), power
Remove protective film covering the
supply (D) and material cartridge (E).
display (A).
A
Installing Material Cartridge
4.
Insert the material cartridge into the
material cartridge support and then
1.
Lift the material cartridge clamp lever
under the material cartridge clamp.
(A) up to raise the cartridge clamp.
2.
Remove cartridge from foil package,
NOTE: The material cartridge will
cut end with scissors.
set into a pocket on top of the
NOTE: Look in the foil bag to
glass pane.
ensure there is no resin inside
CAUTION: It is very important
bag. If resin is present do not insert
that the cartridge be seated
cartridge in the machine.
correctly in the pocket or else
3.
Check material cartridge to ensure
a leak can be created in the cartridge
tab is folded over and facing the front
which may damage the system.
of machine, if not, fold over now.
B
C
D
E
Install curing bulb
Open curing door and hold the curing
bulb with tissue or paper towel, with
notch facing up. Insert end of bulb down
in hole behind carousel and insert bulb
base up into socket ensuring it locks in
place.
5.
Rotate the material cartridge clamp
lever (B) down to lower the cartridge
clamp (A).
NOTE: Ensure the clamp is locked.
If the clamp requires a lot of
pressure to lock, check that the cartridge
is seated properly in the pocket.
NOTE: Only put a cartridge in
the machine and clamp it once.
Repeating clamping can break the seal
between the film and the cartridge.
Hold bulb with tissue
or paper towel to
avoid damaging.
NOTCH
A
B